Fitting a 1 Piece Closed (Colostomy) Pouch

	If you are using a drainable or urostomy product, ensure that the clip or tie has been applied first (see Drainable Pouch Closure Mechanisms). If you are using a urostomy appliance please make sure that the tap is in the closed position
	Hold the flange between your hands for a minute or so, to enable the hydrocolloid to warm up. This helps with its adhesive properties and ensures a secure bond
	Remove the backing paper (or ‘release Paper’) from the flange using the easy release tab
	To ensure a snug fit, fold the flange in half away from the body and place the bottom of the hole in the flange around the underside of your stoma. Work the whole flange into place
	Run your fingers around the edges to make sure the flange is secure

Removal of the closed pouch

	Carefully lift and peel the wafer slowly downwards
	With the other hand apply pressure to the abdomen to aid comfortable removal. This also helps reduce trauma to the skin

Disposal of a Closed Pouch

	Unless you are using Welland’s disposable pouch (FreeStyle^® Flushable, Flair Xtra^® or Impact^®) DO NOT attempt to flush any part of your pouch down the toilet as it may block your sewage system
	The contents of your pouch should be emptied into the toilet prior to disposal
	If you are using a drainable pouch, the plastic clamp can be kept for future use; however the wire ties are disposable

1 Piece Drainable (Ileostomy pouch) Closure Mechanisms

Clamps

	Place the inner bar of the clamp against the tail of the pouch
	Fold the end of the pouch once over the bar, ensuring that there are no wrinkles
	Press the clamp firmly until the latch closes
	CLAMPS ARE REUSABLE

Ties

	Remove the release paper from the adhesive strip
	Apply the soft tie across the tail of the pouch
	Press down firmly to achieve a good bond
	Roll the soft tie closure through three complete turns and fold the ends forward towards you to secure
	SOFT TIES ARE FOR DAILY USE ONLY

1 Piece Urostomy Pouch Closure Mechanisms

Emptying the pouch

To Open

	To open the soft tap – hold the tap upright to prevent urine from spilling out
	Squeeze the soft tap just below the ridges and carefully remove the stopper

To Drain

	Direct the outlet into the toilet (or jug)
	The flow can be controlled if necessary, by gently squeezing the soft tap. You may need to hold the stopper out of the way to prevent urine from emptying onto it
	Gently shake the soft tap to drain any residual urine or wipe the end of the soft tap with a piece of toilet tissue

To Close

	Hold the soft tap upright
	Place the stopper securely into the soft tap